News:

  • June 09, 2026, 03:12:34 AM

Login with username, password and session length

« previous next »
Pages: [1]

Author Topic: DL 05 hepl  (Read 10706 times)

acoudvnjak

  • Newbie
  • *
  • Posts: 2
DL 05 hepl
« on: September 02, 2010, 10:33:33 AM »
Hi, I work  acces control and I use DL 06 as my PLC. I have tried to send data (password) form HMI to PLC via comm port1. Lamps on PLC are blinking but I dont know (if it is posible) how to see my results. Also I need to connect PLC to PC via Comm port 2 and to send data form HMI to PC. Can anyone help me ??? Thanks
Logged

b_carlton

  • Internal Dev
  • Hero Member
  • ****
  • Posts: 606
    • thePLCguy
Re: DL 05 hepl
« Reply #1 on: September 02, 2010, 12:44:47 PM »
1. Have you written the DL06 program and downloaded it to the PLC? Does it run correctly?

2. What type HMI are you using? Does it appear to be properly communicating with the PLC? (Do any errors occur?)
Logged
An output is a PLC's way of getting its inputs to change.

acoudvnjak

  • Newbie
  • *
  • Posts: 2
Re: DL 05 help
« Reply #2 on: September 02, 2010, 03:16:31 PM »
I use Weintec MT6100i touch panel and I connect it to PLC as I see in instruction. Also I built some project on it and it works good. I don't write DL06 program ...That's what I need as help
Logged

b_carlton

  • Internal Dev
  • Hero Member
  • ****
  • Posts: 606
    • thePLCguy
Re: DL 05 hepl
« Reply #3 on: September 02, 2010, 03:33:35 PM »
I don't know that display so I can't help you there. If you have Directsoft you can use either port to program/monitor (or even add on an Ethernet card if you have a free slot).
Logged
An output is a PLC's way of getting its inputs to change.
Pages: [1]
« previous next »