Ladder Editor Question

[timk5000]

I am sure I am in the minority on this because I have not ever seen anything mentioned about it before.
The one thing I did not like about the software was the big 3D lines and symbols in the editor. I though it mad it look cheap.
I have since found that the ladder lines can be switched to 2D which is great. But is there a way to switch the contact symbols to 2D also. Am I just over looking it.

Thanks

[franji1]

DirectSOFT or Do-more Designer?  It should be the same behavior, but want to make sure.

[BobO]

This is what it's supposed to look like. Is that not what you are seeing?

[timk5000]

Thanks

It is Do-More Designer
When I switch to 2D the ladder section looks fine.
I select the option to use a visual studio type layout
The column to the right where you select the type of contact or coil still has the 3D images.