News:

  • May 01, 2026, 02:01:30 PM

Login with username, password and session length

« previous next »
Pages: [1]

Author Topic: How to update ECOM firmware if no broadcast?  (Read 17078 times)

Henryp

  • Hero Member
  • *****
  • Posts: 161
How to update ECOM firmware if no broadcast?
« on: July 17, 2015, 11:17:06 AM »
I have a wireless network connecting remote PLCs and using layer 3 switches.  How can I update the firmware if Netedit can’t see the ECOM card because the switches don’t pass broadcast traffic?

Thanks
Logged

BobO

  • Host Moderator
  • Hero Member
  • *****
  • Posts: 6154
  • Yes Pinky, Do-more will control the world!
Re: How to update ECOM firmware if no broadcast?
« Reply #1 on: July 17, 2015, 04:10:28 PM »
This has come up a few times before...so...we are doing a new version of NetEdit that will allow you to connect to a single device by specifying the address. Stand by...
Logged
"It has recently come to our attention that users spend 95% of their time using 5% of the available features. That might be relevant." -BobO

Henryp

  • Hero Member
  • *****
  • Posts: 161
Re: How to update ECOM firmware if no broadcast?
« Reply #2 on: July 17, 2015, 06:19:17 PM »
Thanks, we have more than 75 ECOM cards in the distributions system.
Logged

BobO

  • Host Moderator
  • Hero Member
  • *****
  • Posts: 6154
  • Yes Pinky, Do-more will control the world!
Re: How to update ECOM firmware if no broadcast?
« Reply #3 on: July 17, 2015, 06:21:53 PM »
It's coded and works. We're going to test a bit more and should roll it out early next week.
Logged
"It has recently come to our attention that users spend 95% of their time using 5% of the available features. That might be relevant." -BobO
Pages: [1]
« previous next »