Restarting the counter and preset table.

[ERokc]

I need to reset the counter and load a preset table to produce an output on corresponding count values.
Prior to completion of the preset table I need to reset the counter and start the table over.

Do I need to clear the table and reload it when the counter gets cleared?

If I load a table without clearing first will it load over the old one?

[BobO]

Do I need to clear the table and reload it when the counter gets cleared?

No. Resetting the counter also resets the table.

If I load a table without clearing first will it load over the old one?

Yes.

[ERokc]

That's the answer I wanted.  I simply want to reset the counter and start the same table again.

Thanks

[ERokc]

I'm writing my instructions and realize the photo sensors detecting an edge are offset from the datum.  I need to set the counter to 750, not zero.  That I can do but how do I reset the preset table that's loaded?  Load it again or is there a table reset function?
 

[BobO]

The table is reset by the counter being reset. Just use CTREGWR to update the counter with the desired reset value, then reset the counter however you normally do.