One of my assignments at work has been to try..

[ealltech]

Hello,

One of my assignments at work has been to try and get the H2-ECOM100 email to work so that we can start utilizing this on projects. I have been messing around on this, and have made very little headway, but I am learning through failure. It turns out that our email server at work requires more sophisticated authentication than what the ECOM100 can provide. Well, what about Gmail. From what I read, this only works on Do-More processors. Almost all our installations are DL260 processors. What I am looking into now is a good SMTP relay. Something that I can setup on a Embedded Single Board Computer (or maybe a Raspberry Pi or Graperain?) and use as an email server that will then pass the email through to a legitimate Gmail (or equivalent) account. I have dabbled in the IT world, but am no where near an pro. I have tried setting up hMailServer on my laptop but haven't had any success getting the emails through that. I am really looking for something "stupid simple". I would appreciate any suggestions.

Thank you,

[rainsee]

 I don't believe even pre-1.4 Do-Mores will email from a Gmail account, because Gmail uses separate POP and SMTP server urls, but uses POP before SMTP login.  Until 1.4, this was a combination that would confound Do-More.   As of v1.4, Do-More has added the ability to DEVWRITE the POP server IP address, so using Gmail accounts should now be possible, but I haven't tried it yet.

[ealltech]

I can setup on a Graperain Single Board Computer. It offer for below inquiries
Core: ARM Cortex-A53 octa core;Frequency：1.4GHz+*8；Memory: 2GB DDR3, 1GB DDR3;   Flash: 4GB / 8GB / 16GB/32GB EMMC optional, default 8GB emmc;    24bit RGB interface;8bit LVDS interface;VGA interface supportedMIPI DSI interface2 channels USB HOST interface, support more USB devices used together;USB OTG interface;2 channels TTL electrical level UART interface;2 channels TF card interface;2 channel LEDReset key;