Use H2-EBC100 Do-More Slave Serial Port to C-More Micro

[davidbgtx]

Can I communicate to a C-More Micro thru the serial port on an H2-EBC100 which is a slave in a Do-More system. If so where to I configure the serial port on the H2-EBC100 in in Do-More Designer?

[franji1]

Sorry, no.

The serial port only gives you access to local I/O on the EBC - it also emulates DL V memory and possibly also emulates Modbus Holding Registers (don't hold me on that), but the EBC serial port cannot communicate back to its Ethernet "Master" at all (not DL, not Do-more, not Modbus).