Dol Starter PLC Program

[Meyers Mills]

I am a newbie,
I  have  been using DoL Starters for years but, I want practical guide on how  a DoL  is implemented using plc.
I want to know how the N0 Start PB /NC Stop is wired at input terminals of the plc.
Thanks

[Bolt]

Typically the Start Push Button is not used, the starter's Hand/Off/Auto switch is put into Auto, and that is energized via a PLC output.  You might like to have an auxiliary contact on the starter wired to a PLC input, telling the PLC if the starter is energized.