Host Engineering Forum
General Category => CTRIO and CTRIO2 => Topic started by: Davecassano on October 29, 2010, 06:41:07 PM
-
Hello. First time trying to configure an H4-CTRIO Module. Trying to use the CTRIO workbench but it never sees the counter module in the PLC rack. When I select the PLC the "Link Active" box is checked but nothing ever shows up. Any ideas on what I am doing wrong? The only boxes available to me are "Clear Config" and "Quit".
Thank you for any help,
David
-
first thing is to make sure the link you setup is configured to use K-Sequence protocol.
also make sure there are no bent pins on the backplane connector.