Host Engineering Forum

General Category => DirectSOFT => Topic started by: scottk on August 01, 2012, 10:36:06 AM

Title: Pausing DL06 Slave Outputs
Post by: scottk on August 01, 2012, 10:36:06 AM

Hello,
I know that you cannot pause outputs in a slave PLC (GY0,GY1, etc.), but I was wondering if anybody knew a workaround for this? This is for a car wash where we would like to be able to pause the wash and resume it with the press of a button and unfortunately some of what we need to pause is on a slave plc. (connected via H0-ECOM 100 through switch)

Title: Re: Pausing DL06 Slave Outputs
Post by: LWgreys on December 01, 2013, 05:21:01 PM

May be an old topic, but the MLS MLR instruction may work well for this.