Host Engineering Forum

General Category => DirectSOFT => Topic started by: DSTAUF on January 18, 2010, 03:27:21 PM

Title: changing status in data view
Post by: DSTAUF on January 18, 2010, 03:27:21 PM

I'm using a D0-06AR and in DS5 I'm trying to overide my outputs in the data window. I've been able to do this with 205's, but I keep getting a message about not being able to write a single bit. I'm attempting to change ON and OFF. Any ideas what I'm doing wrong.

Title: Re: changing status in data view
Post by: b_carlton on January 18, 2010, 03:48:50 PM

Mkae sure that your link is set up using K-Sequence