Host Engineering Forum

General Category => DirectSOFT => Topic started by: JohnB on December 16, 2009, 04:53:06 PM

Title: Directsoft feature request
Post by: JohnB on December 16, 2009, 04:53:06 PM

I don't know if this has been asked about before, but I would like to have the capability of copying and pasting within a rung on the input or output side of the rung, as well as being able to copy and paste the entire rung as you can do now. I do a lot of programming with multiple rungs that have similar instructions on the rung, and it would be useful to be able to select a group of instructions within a rung, and copy and paste them within a second rung.

Title: Re: Directsoft feature request
Post by: Controls Guy on December 22, 2009, 12:55:22 PM

You don't have a sloop, do you?

Title: Re: Directsoft feature request
Post by: JohnB on December 22, 2009, 01:29:49 PM

If you are talking about a sailboat, no, I don't.

Title: Re: Directsoft feature request
Post by: ATU on December 27, 2009, 10:07:52 PM

I know that tune.

Title: Re: Directsoft feature request
Post by: b_carlton on December 27, 2009, 10:59:00 PM

But I came on one and so did my grandfather.

Title: Re: Directsoft feature request
Post by: JohnB on December 27, 2009, 11:13:28 PM

Now this is what I call a thread drift.

Title: Re: Directsoft feature request
Post by: ATU on December 28, 2009, 08:05:48 AM

Sorry, I hope you don't wanna go home?

Title: Re: Directsoft feature request
Post by: JohnB on December 29, 2009, 01:16:49 PM

No, but if I had read more in the new features wanted section under general discussion before I made this post, I would have seen that this feature had already been asked for several times.