Host Engineering Forum
General Category => Do-more CPUs and Do-more Designer Software => Topic started by: jemcotech on August 05, 2026, 07:15:19 PM
-
I have a machine that I upgraded to BRX a few years ago. Recently, one of its obsolete, hardwired valve manifolds died and we replaced it with a Nitra PAL. Everything worked as expected until the machine was power cycled (which is infrequent). After power is restored, we have a link led but no activity led. The only way I can get it to start scanning again is to go to System Configuration -> Ethernet/IP Scanner, then click "Find Adapters..." and then click "Query Adapters". This is the only thing I have found to make the scanner start scanning again.
So initially I found this post https://forum.hosteng.com/index.php?topic=4062.msg29877#msg29877 (https://forum.hosteng.com/index.php?topic=4062.msg29877#msg29877) and was hopeful when I saw that I was on version 2.11.0 however going to 2.11.2 and 2.11.3 has had no effect.
BX-DM1E-36ER3 with an ECOMEX POM directly to PAL (no switch). BRX is 2.11.3 (not sure of the pom version - machine is remote although it was purchased in June of this year). Ideas? Suggestions? Need more information? Thank you.