Host Engineering Forum

General Category => DirectSOFT => Topic started by: dieseltwitch on May 13, 2009, 03:03:56 PM

Title: Working with decimals
Post by: dieseltwitch on May 13, 2009, 03:03:56 PM

Ok so in the last week I have learned a lot from you guys but I have another question. Im reading a temp from and RTD card and its working fine but when i display it on my HMI (3" touch) how do i move the decimal so that it will read 71.2*F rather then 712*F?

Title: Re: Working with decimals
Post by: dieseltwitch on May 13, 2009, 03:10:39 PM

Never Mind! i figured it out moments after asking!