Host Engineering Forum

General Category => Do-more CPUs and Do-more Designer Software => Topic started by: MBAutomation on January 09, 2021, 09:41:03 PM

Title: RX/ WX vs Ethernet IP
Post by: MBAutomation on January 09, 2021, 09:41:03 PM

Hello,

I am working on a project that will use 4 PLC's in the end.  I'm trying to figure out which method will be best for sharing memory and info between the 4.    Is the Do-More protocol going to be best, or will using an EIP message be best?

One more question.   Can a Cmore HMI talk to multiple PLC's?

Thank you

Title: Re: RX/ WX vs Ethernet IP
Post by: BobO on January 09, 2021, 10:32:29 PM

Quote from: MBAutomation on January 09, 2021, 09:41:03 PM

Hello,

I am working on a project that will use 4 PLC's in the end.  I'm trying to figure out which method will be best for sharing memory and info between the 4.    Is the Do-More protocol going to be best, or will using an EIP message be best?

One more question.   Can a Cmore HMI talk to multiple PLC's?

Thank you

Between Do-more PLCs? Yes, RX/WX.

Not a C-more guy, but I think so.

Title: Re: RX/ WX vs Ethernet IP
Post by: RBPLC on January 09, 2021, 10:42:27 PM

C-More can talk to multiple PLC's at once. Depending on how much data you need to share you could also potentially use Peerlink.

Title: Re: RX/ WX vs Ethernet IP
Post by: MBAutomation on January 09, 2021, 11:49:03 PM

Thank you.  I appreciate it.

Title: Re: RX/ WX vs Ethernet IP
Post by: Garyhlucas on January 10, 2021, 08:44:41 AM

I am doing the the same thing with 3 BRX PLCs so thanks for asking!