Host Engineering Forum

General Category => General Discussion => Topic started by: MinusMyX on March 04, 2020, 12:55:08 AM

Title: Creating a Program
Post by: MinusMyX on March 04, 2020, 12:55:08 AM

I was creating a new program and had a white space in the name. The red diamond appeared. I corrected it but the red diamond stayed red. I just pressed okay anyhow and all was good. Is this normal behavior after correcting the name?

Title: Re: Creating a Program
Post by: franji1 on March 04, 2020, 10:12:55 AM

Are you doing this in the Create New User Code Block dialog? The bulb should have turned yellow (valid new heap item name).  Maybe it was too long also? (but then it should have told you that).

Or was this in a RUN instruction editor (you can indirectly create code-blocks from the RUN, ENTASK, and CALL instructions)?