Host Engineering Forum

General Category => Do-more CPUs and Do-more Designer Software => Topic started by: Mike Nash on August 06, 2018, 01:01:54 PM

Title: Do-more Simulator IntSerial StreamIn StreamOut
Post by: Mike Nash on August 06, 2018, 01:01:54 PM

Probably covered before, but I can't find anything.

I don't seem to be able to select @IntSerial in the Simulator for a StreamIn or StreamOut instruction. Is there a workaround/alternative?

This is just me trying something out as the code works fine in a BX and H2. I don't find anything in Help saying it won't work. I do have the physical Com port selected in DMSim and I've restarted DMSim.

Title: Re: Do-more Simulator IntSerial StreamIn StreamOut
Post by: BobO on August 06, 2018, 01:58:25 PM

You need to change the port mode from the default "Do-more Protocol" to "Program Control". CPU page of the SysConfig.

Title: Re: Do-more Simulator IntSerial StreamIn StreamOut
Post by: pbw on August 06, 2018, 02:13:39 PM

Say I have a device streaming data to COM 1 on the PC is it possible for the SIM to see this? If So how do I direct the SIM to COM1?

Title: Re: Do-more Simulator IntSerial StreamIn StreamOut
Post by: pbw on August 06, 2018, 02:17:39 PM

Found it.

Title: Re: Do-more Simulator IntSerial StreamIn StreamOut
Post by: Mike Nash on August 06, 2018, 02:46:42 PM

Quote from: BobO on August 06, 2018, 01:58:25 PM

You need to change the port mode from the default "Do-more Protocol" to "Program Control". CPU page of the SysConfig.

Thank you! I was pretty sure I had it working before but I clean overlooked that in the Sim this time.