Host Engineering Forum

General Category => Do-more CPUs and Do-more Designer Software => Topic started by: ATU on June 28, 2018, 01:35:01 PM

Title: Link Editor
Post by: ATU on June 28, 2018, 01:35:01 PM

Uninstalled 2.2 and installed 2.3.  Can't setup an Ethernet link. When I go to select the Adapter, Only Default is an option. Yet, when I open up NetEdit3, I get all the adapters on the dropdown and can see the PLC out there. See photo. I don't know how to get past this.

Title: Re: Link Editor
Post by: franji1 on June 28, 2018, 01:43:26 PM

Not sure.  Try rebooting.

If that doesn't work, you may need to reinstall 2.3 (try right click/Run As Admin on the Setup exe), although I am not sure if that will actually fix it.

Title: Re: Link Editor
Post by: ATU on June 28, 2018, 02:21:18 PM

Tried all that.  I think its strange that it works for NETEDIT3 and not the link editor

Title: Re: Link Editor
Post by: franji1 on June 28, 2018, 03:24:56 PM

2.2 and 2.3 should have worked the same.  Hmmm...  :(

Title: Re: Link Editor
Post by: ATU on June 28, 2018, 03:54:17 PM

I was able to modify the IP address from a link created in 2.2 and be able to use it, but I still can't create a new link.

Title: Re: Link Editor
Post by: franji1 on June 28, 2018, 03:58:14 PM

I sent you an email.

Title: Re: Link Editor
Post by: franji1 on June 28, 2018, 04:52:14 PM

We figured it out - PC issue.

Title: Re: Link Editor
Post by: Controls Guy on June 28, 2018, 06:54:38 PM

That damned political correctness ruins everything!

Title: Re: Link Editor
Post by: ATU on June 28, 2018, 10:23:31 PM

Deleted and reinstalled the Network Adapter Card driver. Somehow it had 2 IP addresses assigned.