Host Engineering Forum
General Category => Do-more CPUs and Do-more Designer Software => Topic started by: bellni on April 28, 2018, 05:35:15 PM
-
Hello,
Just did a project that involved a Do-More rack and 3 remote racks filled with serial cards communicating with scales. I had to bring some of the scale weights into the main rack, and the rx command JUST WORKED!! such a relief.
I did have a suggestion. I had to initialize around 150 parameters using INIT command. When i put 50 in one command the command became very large and made going through the program rather hard. It would be nice if after 15ish entries a scroll bar would appear.
Is there any plan to bring Stage View back? was a great feature!