Host Engineering Forum

General Category => Do-more CPUs and Do-more Designer Software => Topic started by: DLTimmons on April 10, 2018, 04:46:41 PM

Title: RAMPSOAK
Post by: DLTimmons on April 10, 2018, 04:46:41 PM

I have a rampsoak in a program I ramp to a set point then soak for so long then ramp back down. My problem there are times when I need to cut the ramp off jump to the ramp down from the point I had ramped to. What I see going on is when I step out of the ramp step to and thru the soak it take the output to the final soak value and starts the ramp down from the peak soak value not were I had ramped to.

Do any of you see a way to do what I'm looking for?

Title: Re: RAMPSOAK
Post by: BobO on April 10, 2018, 05:10:34 PM

I see the issue. Not sure how to work around it.

Title: Re: RAMPSOAK
Post by: DLTimmons on April 10, 2018, 06:43:29 PM

Leave to me to find something like this ;D

I was hoping I was doing something wrong :(