Host Engineering Forum

General Category => ECOMs and ECOM100s => Topic started by: Henryp on April 10, 2018, 11:23:52 AM

Title: Firmware modification request
Post by: Henryp on April 10, 2018, 11:23:52 AM

Can you modify the firmware in an Ecom 100 to use a non standard Modbus port. I'm taking a SCADA security class and they are suggesting we do this. I have already done this with our Do More PLCs and would like to do this on the Direct Logic PLCs.

Title: Re: Firmware modification request
Post by: BobO on April 11, 2018, 10:37:11 AM

It is currently possible to add new ports (although NetEdit has to be updated to support it), but it is not possible to disable the standard port. We're looking into it.

Title: Re: Firmware modification request
Post by: BobO on April 12, 2018, 12:44:25 PM

We looked into it and we are going to implement it. We hope to have it in the next version of NetEdit, which should be out next month.

Title: Re: Firmware modification request
Post by: Henryp on April 16, 2018, 07:05:58 PM

Thank you

Title: Re: Firmware modification request
Post by: Henryp on May 30, 2018, 11:52:10 AM

Thank you for adding this feature.

Title: Re: Firmware modification request
Post by: BobO on May 30, 2018, 01:44:19 PM

Quote from: Henryp on May 30, 2018, 11:52:10 AM

Thank you for adding this feature.

You're welcome!