Host Engineering Forum

General Category => Do-more CPUs and Do-more Designer Software => Topic started by: davidbgtx on October 11, 2017, 10:45:26 AM

Title: Password Config
Post by: davidbgtx on October 11, 2017, 10:45:26 AM

1st time for me at setting the passwords. I would like to set a user to be able to connect to the Do-More PLC and display all status, but not be able to change anything. To enable the user to connect, I must at least check RP, but this allows forcing and changing data. Or am I missing something?

Title: Re: Password Config
Post by: BobO on October 11, 2017, 10:59:57 AM

Quote from: davidbgtx on October 11, 2017, 10:45:26 AM

1st time for me at setting the passwords. I would like to set a user to be able to connect to the Do-More PLC and display all status, but not be able to change anything. To enable the user to connect, I must at least check RP, but this allows forcing and changing data. Or am I missing something?

Read Data and Read Program should not allow writing data.

Remember that setting the password doesn't invalidate the session you are currently connected under, only establishes the settings for future connections.

Title: Re: Password Config
Post by: davidbgtx on October 11, 2017, 11:24:43 AM

I thought since default was rd wd that was minimum to connect, stupidly I didn't realize I could choose rd and rp without wd. Thanks

Title: Re: Password Config
Post by: BobO on October 11, 2017, 12:04:42 PM

I think we set the default limited permissions to support HMI.