Host Engineering Forum

General Category => General Discussion => Topic started by: timk5000 on August 29, 2017, 04:08:47 PM

Title: Ladder Editor Question
Post by: timk5000 on August 29, 2017, 04:08:47 PM

I am sure I am in the minority on this because I have not ever seen anything mentioned about it before.
The one thing I did not like about the software was the big 3D lines and symbols in the editor. I though it mad it look cheap.
I have since found that the ladder lines can be switched to 2D which is great. But is there a way to switch the contact symbols to 2D also. Am I just over looking it.

Thanks

Title: Re: Ladder Editor Question
Post by: franji1 on August 29, 2017, 04:40:39 PM

DirectSOFT or Do-more Designer?  It should be the same behavior, but want to make sure.

Title: Re: Ladder Editor Question
Post by: BobO on August 29, 2017, 04:52:14 PM

This is what it's supposed to look like. Is that not what you are seeing?

Title: Re: Ladder Editor Question
Post by: timk5000 on August 30, 2017, 04:19:21 PM

Thanks

It is Do-More Designer
When I switch to 2D the ladder section looks fine.
I select the option to use a visual studio type layout
The column to the right where you select the type of contact or coil still has the 3D images.