Host Engineering Forum

General Category => General Discussion => Topic started by: PLCGuy on June 21, 2017, 11:51:20 AM

Title: POM info
Post by: PLCGuy on June 21, 2017, 11:51:20 AM

I am not seeing how to setup the Ethernet POM. The help file shows the ibox for the POM serial. But what about the ethernet? I went into Configuration and I only see the @intEthernet. On the @POM it shows settings that look like serial settings. How do I set up the POM ethernet?

Title: Re: POM info
Post by: BobO on June 21, 2017, 12:03:05 PM

Either with NetEdit, or through the POM config page accessed from the SysConfig's CPU page or by clicking on the picture of the POM in the Dashboard.

Title: Re: POM info
Post by: PLCGuy on June 21, 2017, 12:46:31 PM

darn it was right in front of me. I clicked on the POM in Sys Config, and it shows for both the serial and ethernet. So simple, I think that is why I did not see it.

Title: Re: POM info
Post by: BobO on June 21, 2017, 12:52:14 PM

Since the POM can be hot swapped, you are configuring for all possible POMs.

Title: Re: POM info
Post by: PLCGuy on June 21, 2017, 06:15:24 PM

stop making things so easy, your going to get a good reputation.