Host Engineering Forum

General Category => General Discussion => Topic started by: PLCGuy on January 04, 2017, 07:17:11 AM

Title: C-More Micro
Post by: PLCGuy on January 04, 2017, 07:17:11 AM

Need help setting up the serial port to communicate with a 3" C-More Micro. I tried all settings, but no luck.
Using 38400/ 1 stoop / none parity.
Can not find anything in the help file.

Title: Re: C-More Micro
Post by: ADC Product Engineer on January 04, 2017, 08:27:57 AM

The port on the Do-more needs to be set to "Programming".   The C-more should be using the Do-more Serial driver.

Title: Re: C-More Micro
Post by: PLCGuy on January 04, 2017, 10:16:16 AM

I feel so stupid, the cpu went into program mode when I changed the configuration. I did not know it. All is good. I did not think it should have been that hard to do.

thank you for replying.