Host Engineering Forum

General Category => EDRV => Topic started by: Henryp on October 10, 2016, 03:58:47 PM

Title: Electrical motor running data
Post by: Henryp on October 10, 2016, 03:58:47 PM

Can the EDV100’s built in web page have another display screen added that would show actual electrical motor running data like volts, amps, frequency and dc bus?

Title: Re: Electrical motor running data
Post by: BobO on October 10, 2016, 05:07:45 PM

I'll have to talk to the engineer, but that doesn't sound difficult.

Title: Re: Electrical motor running data
Post by: Henryp on October 13, 2016, 03:22:30 PM

The information that would be nice is the durapulse status addresses shown on page 5-11 of the manual. (Modbus locations 48449 to 48465) Also, if it is possible,  the GS3 key pad has run, stop, jog, fwd and rev lights that show status if that information could be read it would be great. The EDVR module is a good unit that makes reading a drive's configuration a lot easier.