Host Engineering Forum

General Category => DirectSOFT => Topic started by: jblsoftware on May 18, 2008, 06:30:29 PM

Title: DL250-1 Port #2 Communications
Post by: jblsoftware on May 18, 2008, 06:30:29 PM

18 May 2008

Is there a way to use Port #2 on a DL250-1 processor to read ASCII data?

Title: Re: DL250-1 Port #2 Communications
Post by: franji1 on May 18, 2008, 07:27:13 PM

No, you can only output data via Port 2 on a 250.  To read data w/250-1 you need a Basic Co-Processor module OR change your CPU to a 260, which does support input.