Host Engineering Forum

General Category => Do-more CPUs and Do-more Designer Software => Topic started by: Garyhlucas on April 10, 2015, 09:55:17 AM

Title: FlipFlop
Post by: Garyhlucas on April 10, 2015, 09:55:17 AM

Does Do-More have a flipflop relay?  Pulse it once it is on, pulse it again it is off.  For years I've been getting this functionality by a using a counter and reading the least significant bit. My homebuilt CNC has a DL06 salvaged from an old job and I control the shop vac from an outlet controlled by a single pushbutton programmed this way.  I have two buttons on different sides of the machine for convenience.  Seem like it is time for this function to make it into a PLC as an instruction!

Title: Re: FlipFlop
Post by: plcnut on April 10, 2015, 10:12:29 AM

PONOFF

Title: Re: FlipFlop
Post by: Garyhlucas on April 17, 2015, 06:11:28 PM

Just took a look at that, very nice! Thanks for pointing it out.

Title: Re: FlipFlop
Post by: boardmaker on April 21, 2015, 09:59:53 AM

One of my favorite instructions!  Thanks Host.