Host Engineering Forum

General Category => DirectSOFT => Topic started by: chiali on December 16, 2007, 11:26:07 AM

Title: Out box
Post by: chiali on December 16, 2007, 11:26:07 AM

Hi everybody

How to get, in DS5, the Out-box instead of the Out coil by typing Out then Enter.

Thanks.

Chiali.

Title: Re: Out box
Post by: b_carlton on December 16, 2007, 02:50:00 PM

After pressing the Enter press the '/' key. This will change it to the OUT WORD instruction. Using the '/' key will also toggle a contact between NO and NC. Another use is to step through the various inline comparison instructions.

Title: Re: Out box
Post by: chiali on December 16, 2007, 04:06:48 PM

Thanks for the answer ;I tried it and it's OK...

Thanks again.

Chiali.

Title: Re: Out box
Post by: MikeS on December 17, 2007, 09:02:49 AM

another way to get there is to hit the 'F7' key then type OUT, F7 is the 'Box Browser', so it selects the OUT Box by default instead of the OUT Coil.