Host Engineering Forum

General Category => DirectSOFT => Topic started by: ftnguy on January 11, 2019, 10:26:02 AM

Title: Timers
Post by: ftnguy on January 11, 2019, 10:26:02 AM

I have been programming with RSLogix for years but new to Directsoft.  When using a timer,  how do you use a bit tied to that timer for an enable bit or a done bit or a timing timer bit?

Title: Re: Timers
Post by: b_carlton on January 11, 2019, 11:14:24 AM

Enable - parallel the timer with a C bit coil

Timing - parallel the timer with an XIO of the timer Done bit to a C bit coil

http://www.theplcguy.com/ABtoAD/TimersAndCounters.htm