Host Engineering Forum

General Category => General Discussion => Topic started by: PLCGuy on July 10, 2017, 12:14:37 PM

Title: Firmware UpDate
Post by: PLCGuy on July 10, 2017, 12:14:37 PM

Why when I use Netedit3 on my BRX it shows the click marks in the F & B Blocks? I take that means out of date. But when I use Do-More and check, it shows the Firmware and Boot is up to date.

Title: Re: Firmware UpDate
Post by: BobO on July 10, 2017, 02:13:43 PM

Sounds like you have an old copy of NetEdit. Do-more CPUs cannot be upgraded through NetEdit and it should just show a dash in those columns.

Title: Re: Firmware UpDate
Post by: PLCGuy on July 11, 2017, 11:50:33 AM

Yes, sorry they were dashes. I did not know not to use Netedit on the Do-More. I just happened to open it up since in was in the list of the left pane. Maybe I should delete it from the list since it is not used to update the Do-More.

Title: Re: Firmware UpDate
Post by: BobO on July 11, 2017, 11:52:39 AM

Quote from: PLCGuy on July 11, 2017, 11:50:33 AM

Maybe I should delete it from the list since it is not used to update the Do-More.

It's still a viable tool for setting up the Ethernet port.